-
Contact: info [at] trainaidsa [dot] com
- Home
- Shop
- Conductives
- Elektrizmos
- Fasteners
- LED Items
- All Items
- C5 (Cartridge)
- CR5 (Reverse Polarity)
- E5 (Screw Mount LED)
- E10 ( Lionel )
- L2S ( Lionel )
- L1T ( Lionel )
- L3 ( Lionel )
- W3 (3mm Wired+Resistor)
- W5 (5mm Wired+Resistor)
- SMD-3528
- S5 (5v ver. of S12 Strip)
- S12 (LED Lighting Strip)
- S12K (Lighting Strip Kit)
- S50 (Long LED Strip)
- FX (Flexible Strip)
- ACW (Mini Rectfier Feed)
- Strip Connectors
- Märklin Items
- Fulgurex Motor
- NEM Coupler Adapters
- T-Gauge
- Tech & Support
- Conductives
- Elektrizmos
- Fasteners
- LED Items
- Motors
- NEM Coupler Adapters
- T-Gauge Support
- Gallery
- Conductives
- Fasteners
- Our LED Strips
- 3mm & 5mm LEDs
- SMD LEDs
- T-Gauge
- Other Sections
- Devices & Circuits
- Whiteboard
- Oddments
- Shipping+Availability
- Retailer Inquiries
- About Us
-
How-To-Guide: Motors
Graphical Demonstration of how a Fulgurex Motor works.
Graphics/Design - Courtesy: Club
Stavba
Other Information:
Recommended Operating Voltage: 10 to 14 Volt DC. Operating Current:
approximately 200 mA when motor is running. Switch Current: 5 A
maximum. See our VR2
for a convenient method of converting voltage/power.
Control of the Fulgurex switch machine is via 10-14 V DC power to the two terminals using polarity-reversal.
Two contacts sets are pre-installed. One set of contacts controls
motor actuator, while the extra contact set (one on each side) may be
used for
switching other devices. Additional contact sets available.
|
|
|